Darkness

Today was the first day of the year when I actually had to get up when it was still dark. On the upside, I suppose I'm making efficient use of the available daylight. But I didn't mind the darkness because I used the new shower for the first time!

Why wait so long after fitting it? Because there seems to be a shortage of shower curtain rails. Would you believe it!

I looked in B&Q - the only suitable one (i.e with brackets, rather then the weak-looking friction-fit job) was £60, which was more than I wanted to pay and it didn't look that good anyway because it looked like the curtain would fall off the hooks. I looked in Screwfix, they had exactly the same one as B&Q at £25. (Yes less than half the price - B&Q is so expensive for such things) but were out of stock. In fact they had no stock available for any that I liked. Even ebay had nothing, for once. 

Finally I found one on the internet, which arrived yesterday and was fitted immediately.

Also last night, I tackled the problem in the sink. After being away for a couple of days on a trip, it was not a pleasant job. Wearing latex gloves I tackled the smelly mess.

The problem was of my own making (in two senses of the word). Having been bitten once trying to reuse an old waste trap, I made sure that I bought a new one for the sink. Knowing that space was tight, I bought a nice tidy compact trap.

However, last week, when fitting the front of the sink unit is on, it became clear that there would not be enough room even for this trap: the semi recessed sink sits so that the waste hole is so close to the front of the unit. So I tempted fate and put the old trap on the sink, which was a simple U-bend in the form of a P-trap.

Of course, it was a bad idea.

When I fitted it, it dripped slightly, so I ended up over tightening it onto the waste. This, in itself caused no problems, but when I want to remove it, of course it was stuck tight. Turning harder (which is pretty hard because you cannot really get a spanner to it once the sink is fitted into the unit) just managed to unseat the waste unit itself.

In fact, the trap was stuck so tight that I had to resort to a saw to remove it. 90 minutes later and I had the waste and trap out. 10 minutes after that I had the waste re-seated and sealed, and a new P-trap fitted.

With a sigh of relief, I soaked the few tools that I had used in bleach - I really don't want any chance of a repeat of the events of last weekend.